Estimated reading time: 2 minutes
Introduction
Most engineers and technicians prefer to perform equipment-level repair or PCB-level repair by immediately purchasing new equipment or defective PCBs. The budget required for this ranges from RM500 to RM10,000 for new PCBs or RM5,000 to RM20,000 for new equipment. In contrast, performing component-level repair, which involves repairing the board and replacing faulty components, requires a budget between RM10 and RM200 to resolve the equipment problems. By opting for component-level repair, cost savings of more than 100 times can be achieved compared to purchasing new PCBs or equipment.
Aligning with our vision to develop local expertise up to component-level repair as PCB Repair Specialists, NIQ Engineering Sdn Bhd, an HRD Corp Training Provider & MBOT Approved Training Provider, will conduct Component Level Repair training to enhance engineers’ and technicians’ knowledge, skills, and techniques related to component-level repairs.
About the trainer:
Tc. Ahmad Kamil is Accredited / Certified from HRD Corp Malaysia with working exper-iences more than 20 years in equipment repair and maintenances.
Competency Examination
Malaysian Electromedist Association – MEA
Certification
- Competency – MEA
- Attendance – NIQ
This course is designated for
- Electromedist Biomedical Engineer
- Technologist
- Technical Manager
- Medical Electronic Lecturer
- Students
Fees
This course is HRDC claimable
RM2,000.00 per pax.
Students gets special discount of 50%
Course Modules
- Identification of component specification based on available information on component body
- Generate datasheet PDF of component specification through internet or data books
- Testing and verify status of components using digital Multimeter, LCR Meter and Curve Tracer.
- Comparison wave form / data reference to verify status of components.
- Summarize waveform and data reference of each components.
Learning Outcome
- Understanding of electronic component specification and testing technique.
- Applying components testing and safety procedure.
- Perform testing and measurement of electronic components using Multimeter and Curve Tracer.
- Analyse signal data and waveform reference to verify component status .
- Create electronic component testing checklist according to board required..
Time Table
